Properly level the front of your 2019-2023 Ford Ranger truck by installing this 2.5-inch leveling kit from BDS. Specially designed for the new Ranger this 2.5" leveling kit is engineered for additional tire clearance and improved performance without overextending the suspension or driveline angles at full suspension droop.
To prevent maxing out ball joints or CV damage BDS gets around this issue by using a 2-piece design with a smaller top mounted steel strut spacer in combination with a preload spacer. To further ensure proper drivetrain geometry the front differential is repositioned using relocation brackets. These brackets correct CV axle angle while allowing the use of the factory front skid plates.
The lift kit includes steel top mount strut spacers pre-load spacers differential relocation brackets and custom-tuned NX2 Nitro or FOX Performance series shocks. Give your new Ranger the extra boost with this 2.5" leveling kit from BDS Suspension.
To prevent maxing out ball joints or CV damage BDS gets around this issue by using a 2-piece design with a smaller top mounted steel strut spacer in combination with a preload spacer. To further ensure proper drivetrain geometry the front differential is repositioned using relocation brackets. These brackets correct CV axle angle while allowing the use of the factory front skid plates.
The lift kit includes steel top mount strut spacers pre-load spacers differential relocation brackets and custom-tuned NX2 Nitro or FOX Performance series shocks. Give your new Ranger the extra boost with this 2.5" leveling kit from BDS Suspension.
Features & Benefits:
- Easy 100% Bolt-on installation
- Maintains factory like ride quality
- Standard NX2 Nitro shocks with vehicle-specific valving for better control
- Upgrade to FOX 2.0 Performance Series shocks for maximum performance on and off-road
Associated Comments:
- Aftermarket wheels must have a minimum of 93.1mm center hub bore.
- Tires larger than 285/70r17 or 285/65r18 cannot be installed on factory wheels due to steering knuckle clearance.
- Strut disassembly required high quality wall mounted strut compressor and skilled technichian recommended.
- Will NOT work on trucks equipped with cast steel steering knuckles.
- Wil NOT work with Tremor models.
Additional Attributes:
- GTIN: 00840416403275
- Front Lift Height: 2_5
- Front Lift Method: Strut Spacer
- Installation Difficulty: moderate
- Installation Time: 4 Hrs
- Installation Tools: 35mm Socket Axle Nut Socket-Air Hammer Rec-bit unibit Step Drill Bit-cutOffTool-drill-strutCompressor
- Rear Lift Height: 0
- Rear Lift Method: Stock
- Rear Shock Option: FOX 2 0 Performance Series
- Shocks Included0: Yes
Extended Information:
- Emissions : Emissions Compliance Exempt
- Life Cycle Status: Available To Order
Packaging:
- Quantity of Each: 1
- Package UOM: EA
- Dimension: 48.0000 x 40.0000 x 24.0000 inches
