F1614-ins
For optimal strength, ground clearance and styling the 4" radius arm system is the way to go. This complete kit is designed to lift and level the stance with room for up to 37" tires to be installed. Front lift comes from a pair of front full length coil springs to pair with your choice FOX 2.0 adventure series shocks for optimal ride quality. The front axle is repositioned using a pair of heavy duty replacement radius arms that bolt in place of the factory stamped steel arms. These arms are built from high strength 1/4" steel, boxed and fully welded with large 2.5" greaseable bushings to isolate road vibrations and improve ground clearance over drop bracket kits. Steering correction comes from a forged drop pitman arm to improve operating angle while a massive 1/4" steel fabricated track bar drop bracket is used to recenter the front end and keep the steering linkage angles in phase for predictable handling. Also included for the front are sway bar relocation brackets, brake line drop brackets, bump stop extensions, and single steering stabilizer kit. In the rear these kits retain the factory overload equipped leaf springs and lift is provided via a replacement lift blocks and longer u-bolts specific to the DRW models. Finishing off the rear is a rear brake line bracket and tour choice of rear gas shocks to match the front of the truck.
Features & Benefits:
- Heavy duty fabricated steel replacement radius arms that correct caster alignment while maximizing ground clearance
- Forged pitman arm to correct steering angles
- Heavy duty fabricated track bar relocation bracket to re-center front axle
- Full length Diesel/ Gas specific coil springs for a smooth ride
- Rear lift is specific to dually trucks using U-bolts that are sized correctly for length as well as block height to level the truck and a bump stop extension on the frame
Associated Comments:
- Dually Models Only Diesel Models Only 37x12.50 tires may require minor trimming. Factory wheels fit when paired with factory / original equipment tire size. Two-piece rear drive shaft? Add a carrier bearing drop kit to reduce post-lift driveline angles and avoid / eliminate driveshaft vibration. When adding the Dual Stabilizer option you will get the dual opposing steering stabilizer in addition to the single OE Replacement. Due to taller factory ride height, Tremor models will not net full advertised lift height. Final ride height will be the same as standard models
Additional Attributes:
- GTIN: 00810156366604
- Adjustable: No
- Back Spacing: 4.5"
- Back Spacing 2: 4.5"
- Finish: Powdercoat
- Front Lift Height: 4"
- Front Lift Method: Coil Springs
- Installation Difficulty: 3 out of 5
- Installation Time: 4-6 hrs
- Lift Type: Suspension
- Material: Steel
- Max Tire Size: 37 x 12.5
- Max Tire Size 2: 37 x 12.5
- Rear Lift Height: 3"
- Rear Lift Method: Block Kit
- Required Tools: Wrenches: Standard
- Requires Metal Cutting: No
- Requires Welding: No
- Wheel Size: 22 x 9
- Wheel Size 2: 20 x 9
Extended Information:
- Emissions : 1
- Life Cycle Status: Available To Order
Packaging:
- Quantity of Each: 1
- Package UOM: EA
- Dimension: 48.0000 x 40.0000 x 24.0000 inches
